Installation guide

© 2006 directed electronics
29
z
The remote control channel programmed into this feature will arm/disarm the
system only.
NNOOTTEE::
When programming a new remote control to custom configuration a channel
must first be programmed to this feature before programming the remaining channels.
accessory a output
z
The transmitter channel programmed into this feature will activate the accessory
output.
accessory b output
z
The transmitter channel programmed into this feature will activate the accessory
output.
silent mode
z
The transmitter channel programmed into this feature will arm/disarm the
system, but the siren will not chirp.
remote valet
z
The transmitter channel programmed into this feature will make the system
enter/exit valet mode.
remote start
z
This feature is only available with IntelliStart connected
z
The transmitter channel programmed into this feature will activate or shut down
the Intellistart remote start system.
window control
z
This feature is only available with SmartWindows connected
z
The transmitter channel programmed into this feature will activate the vent or roll
down feature of the SmartWindows system.
clear all remotes
z
This feature will erase all remote codes from the system memory. This feature is
convenient for erasing any transmitters that have been lost, stolen, or incorrect-
ly programmed into the system.
z
After entering this feature press any button on the transmitter; the siren will chirp
to indicate that all transmitters have been erased from memory.