Installation guide

© 2006 directed electronics
30
installer selectable features
To enter the Installer Selectable Features grid follow the instructions for the User
Selectable Features with the exception of step 3. Perform step 3 as described below
to enter the Installer Selectable Features grid.
Hold/Chirp/Release - After entering the PIN code, press and hold until the siren
chirps once. Continue holding for approximately 10 seconds until the siren chirps
three times, then release the button. You have now entered the feature selection posi-
tion of the Installer Selectable Features grid.
* P1 = Pulsed channel output is disabled with the ignition on or the alarm is
armed.
** P2 = Pulsed channel output works anytime.
*** Only with optional IntelliStart connected.
**** Only with optional SmartWindows connected.
*****Remote adjustable sensor port: The 3-pin proximity/shock port can be
used for either the proximity sensor or the remote adjustable magnetic res-
onance impact sensor. This programming branch is used to choose the sen-
sor software. The impact sensor is the default 1 chirp setting. The proximi-
ty sensor is the 2 chirp setting.
Software Select *****
shock / proximity