Installation guide

© 2006 directed electronics
35
z
Programming Procedure
1. Enter the feature location in the user-selectable programming grid.
2. Immediately press and release of the PlainView 2 Valet switch.
3. Select each digit by pressing 1-9 times, and then press to enter
the number into the system. To enter a zero, press only.
z
To program a PIN code of 1032:
1. Press and release once and once. You will hear one chirp.
3. Press and release once. You will not hear a chirp after programming
a zero.
5. Press and release three times, and then press once. You will hear
three chirps.
6. Press and release two times, and then press once. You will hear
two chirps.
4. Wait for two siren chirps after a five second pause or five seconds after the
last digit has been entered if using less than four digit code number.
5. Turn off the ignition; the siren will chirp three times.
6. The programming mode is now exited.
z
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming sequence
or the new code will not be set.
1. Turn on the ignition.
2. Enter the new PIN code.
3. Press and hold for three seconds.
z
LED turns on: New PIN code is learned and programming is
complete.
z
LED stays off: New PIN code is not learned and the system reverts to
the old PIN code. Repeat the programming sequence.
Note #6: Accessory Channels
z
All accessory channels can be programmed to different types of outputs includ-
ing a pulsed output defeated when ignition is on or the system is armed, a pulsed
output regardless of the ignition/armed state, a timed output, a latched output,
or a latched output that resets with ignition on.
accessory output a timer duration
z
Start Timer: Press the arm/disarm button; the siren will chirp to signal the start
of the timer duration setting.
z
Stop Timer: Press the arm/disarm button; the siren will chirp to signal the end of the
timer duration setting, or for maximum time, do not press the arm/disarm button.