Installation guide

© 2006 directed electronics
36
NNOOTTEE::
The timer max setting is 255 seconds.
z
Accessory channel B can be programmed to auto-activate with the arm
command of the transmitter, the disarm command of the transmitter, or both.
Auto-activate can also be turned off and activate as a normal addition accessory
channel output.
accessory output b timer duration
z
Start Timer: Press the arm/disarm button; the siren will chirp to signal the start
of the timer duration setting.
z
Stop Timer: Press the arm/disarm button; the siren will chirp to signal the end of the
timer duration setting, or for maximum time, do not press the arm/disarm button.
NNOOTTEE::
The timer max setting is 255 seconds.
fact II - false alarm control technology
FACT II will bypass an input zone for 60 minutes if the system sees the same zone trig-
gered three times within one hour, the system will bypass that input for 60 minutes. If
that zone does not attempt to trigger the system during the 60 minute bypass period,
the system will begin to monitor the zone again at the end of the hour. If it does
attempt to trigger while bypassed the 60 minute time period starts over. FACT II will
also bypass warn away triggers for the 60 minute duration.
FACT II requires that you change the way you test the system once you have it installed.
Resetting FACT II requires the 60 minute time period expiring without attempted trig-
gers or the ignition to be turned on and off. This allows the system to be repeatedly trig-
gered, disarmed and rearmed, and still allow FACT II to bypass a faulty zone.
NNOOTTEE::
Remember to reset with the ignition when testing sensors.