User Guide

To disarm the security system, turn

the ignition to the "on" position.

Press the Valet switch the preset

number of times (1-5 times) within 15 seconds. After 1.5

seconds the system should disarm. If it does not, you may have

waited too long; turn the ignition off and on and try again.

Location of Valet Switch_________________________________

remote controlled chirp muting

To temporarily turn off the arm or disarm chirps, use Remote

Controlled Chirp Muting. Simply press on the trans-

mitter briefly before arming or disarming, and the confirmation

chirp(s) will be eliminated for that one operation only. If you

want the arm/disarm chirps turned off permanently, your dealer

can do this for you.

panic mode

If you are threatened in or near your vehicle, you can attract

attention by triggering the system with your transmitter! Just

➜

note: The Warning Zone response to lighter impacts is

bypassed if the system is armed using Remote Controlled

Chirp Muting. This ensures that no chirps will be emit-

ted by the siren in an area you want chirp-free. The sys-

tem is still fully capable of triggering. Only the Warning

Zone response is bypassed.

➜

important! The unit can be programmed to respond to 1-5

pulses of the Valet switch for the disarm function. Be sure

to check with the installer for the desired programming.

DRW-35