User Guide

11
© 2001 directed electronics, inc.
press for 1.5 seconds, and you will enter Panic Mode. The
siren will sound and the parking lights will flash for the
programmed siren duration. To stop Panic Mode at any time,
press on the remote transmitter again.
valet mode
You can prevent your security system from automatically arming
and triggering by using Valet Mode. This is very useful when
washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the remote transmitter,
but all convenience functions (door locks, trunk release, etc.)
will continue to work normally.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The LED status indicator will light steadily if you are entering
Valet Mode and will turn off if you are exiting Valet Mode.
remote controlled valet mode
The operations described in this section refer to transmitter
buttons. Remember, the buttons used in all the instructions in
this guide correspond to a Standard Configuration transmitter.
This may not be how your transmitter is set up.
➜
DRW-35
➜