User's Manual

ManualsBrandsClifford ManualsRemote StarterClifford Mobile Security/Convenience System With Built-In Remote Engine Starting ACE 7500

n NOTE 1: Press button 1 on the 16-channel master remote, you will hear one chirp.

Press button 1 again , you will hear two chirps.

n NOTE 2:You will hear two chirps when all features are reset. Valet code and remote

controls are not changed.

n NOTE 3: When you hear two chirps, all remote controls will have been erased from

the system memory. You must now add the new and/or existing remote controls to the

system (i.e., Program each remote that will be used with the ACE 7500).

n NOTE 4: Immediately press the blank button, then immediately enter the new PIN

code. (Example: To enter 4301, you would press: ✱✱✱✱ blank, ✱✱✱ blank, blank, ✱

blank.) Wait for the 2-chirps, then turn off the ignition (3-chirps). IMPORTANT :

You must immediately test the new PIN code: Turn on the ignition, enter the new code,

then press and hold the blank button for 4 seconds. The LED will light to indicate that

the system is in valet mode, enter the code again to exit valet mode. If the LED does

not illuminate, the new code you programmed and the one you just entered do not

match. In such a case, the system will revert to the previous code.

n NOTE 5: Programs a companion remote or any other type remote from another G4

system to arm/disarm this system. For instance, to set button ✱ of the other car’s remote

to arm/disarm this system , select column 4, row 1, then press button ✱ of the other car’s

remote. You’ll hear 1 chirp. Immediately press button ✱ of the other car’s remote

again. You’ll hear 2 chirps.

n NOTE 6: Programs a companion remote or any other type remote from another G4

system to perform the noted function on this system. Select the row and column number,

then transmit the unused button/channel on the other remote that you want to perform

that function. The system will respond with the same number of chirps as the row

number. Please note that you must first set a button on the remote that will arm/disarm

the system (column 4, row 1) before these others will be accepted.

Installer- Programmable Fea tures

To access the installer-programmable features:

1. Turn on the ignition.

2. Enter the valet code (✱✱ blank) on the PlainView 2 switch and immediately hold the ✱

button on the PlainView 2 switch.

3. You’ll hear one chirp after about 3 seconds to indicate user programming mode. KEEP

HOLDING (about 12 more seconds) until you hear the 3-chirp installer programming

mode confirmation.

4. Select the feature column: Press the blank PlainView 2 switch button the number of times

indicated for that column. Pause. You will then hear the same number of chirps as the

column number you have selected, audibly confirming your selection.

5. Within five seconds, select the feature row: Press the ✱ button the number of times

indicated for that row. You’ll hear a chirp each time you press the ✱ button to help you

count.

6. Pause. You will hear either one or two chirps: two chirps = ON, one chirp = OFF.

7. You can select another feature, or you can exit program mode:

a.To select another feature in that same column, repeat step 5 within the next five

seconds (after five seconds, three chirps indicate that the ACE 7500 is now back in the

“Feature Select” position).

b.To select a different feature column, repeat step 4.

c.To exit program mode, turn the ignition off (you’ll hear three chirps and the LED will

turn off to indicate exit of program mode), or wait 60 seconds and the ACE 7500 will

automatically exit program mode.