User manual

Using the 1 way companion remote

The companion 1 way remote commands the system features as

shown in the previous table, but without the message display of the

Responder LC remote. Siren chirps and parking light ﬂashes are used

to indicate that a command has been received and activated as de-

scribed in the Basic and Advanced command sections.

Accessing Commands

Similar to the Responder LC remote, Basic commands are performed

when a command button is pressed directly. To perform Advanced

Commands press the

button 1 to 4 times to access function lev-

els,

x4 in the table for example implies pressing 4 times. The

LED ﬂashes in groups for a few seconds to indicate the level. Press

the desired command button while the LED is ﬂashing to perform the

command.

Button Auto Lock

When On, the remote control buttons lock if more than 20 seconds

lapses between button presses. If a button is pressed when locked, a

fault tone is emitted. To unlock the buttons; press the

button followed

by the

button, the buttons unlock and tones play to conﬁrm.

Car Select

Car 2 must ﬁrst be turned On (See Remote Features menu under “Pro-

gramming” on page 45 to turn on). Press and hold the

button

for 3 seconds. The remote ﬂashes the LED and beeps once or twice to

indicate the selected Car is 1 or 2, release the button for Car Select

or continue to hold for programming.

Release the

button, then press and release while the LED and

beeps continue to perform Car Select. Once the car is selected a com-

mand can be performed by pressing one of the command buttons.