Instructions / Assembly

ClimateRight, LLC. / 777 Manor Park Dr. / Columbus, OH 43228 / Ph: [phone]
climaterightair.com
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
WARNING
!
Thank you for purchasing a ClimateRight
®
product.
Please read this before use.
WARNING: Before doing anything
make sure to power the unit off and
unplug from the receptacle.
For Use With Models:
CR2500ACH, CR5000ACH, & CR10000ACH
The Thermostat Control Panel is connected to the Air
Conditioning Unit by feeding the wire through the Intake
Flexible Air Hose or the hole in the lower right as you are
facing the unit.
Step 1: Remove the hose assembly from the unit so that
you can access the inside of the unit. Remove the filter
before running the wire into the unit.
Step 2: By reaching inside of the intake hole you will feel
the terminal plug that the wire needs to plug into.
Step 3: Plug the wire into this terminal until it snaps.
Step 4: Put the filter back into the unit making sure that
you fish the wire for the thermostat around the filter and
out through the hose assembly. Reconnect the hose
assembly to the unit.
Step 5: It is your preference on how to
mount the thermostat to the interior wall.
Wired Remote Thermostats
Part #: CRWIRETHERMO
* Note: These instructions are for units purchased after May 1st, 2016