Owner`s manual

Page 8 Chapter 2 - Assembly and Setup
• Full Setup or Step and Go: If you choose “Step and Go,” a climber can get on the
ClimbMax and start climbing, without entering any workout information. The
default is “Full Setup.”
When a user chooses “step and go” operation, ClimbMax uses the default
workout length (the one you set as “Def Prog”)and the default weight
setting of 150 pounds (70kg).
• Beep On or Off: Should the console keys beep when pressed? Choose On or Off.
• USA Readout or International (“Intl”): The USA readout uses feet for distance and
pounds for weight. The International readout uses meters and kilos.
3. When you’re done setting options, press the Clear key twice to save your settings and
leave setup mode.
If you decide not to change the settings, turn the climber off without leaving setup mode.
All settings keep their previous values.
Drive Cable Maintenance
With proper maintenance, your Tectrix ClimbMax will provide you with years of trouble-free
exercise. Routine maintenance is essential to not only preserve the life of the equipment, but also to
avoid any possibility of personal injury. Particular attention should be given to the condition of the
ClimbMax drive cables. These cables will eventually wear out. We recommend drive cables be
inspected regularly for signs of wear and replaced every 6 to 8 months with Tectrix-supplied
replacement cables. Failure to perform drive cable maintenance procedures could lead to cable
damage and serious injury.