Installation & Assembly

Table Of Contents

Attach to wall via stud mounting.

Locate studs and align the unit with the location on the wall where you plan to mount it. Ensure unit is level, use a

pencil to mark the top two corners of the unit on the wall, and set the unit aside. Measure 2-11/16 in. down from the

corner marks and make two new marks. Place the bottom of the hang track (M) on top of the two new marks. Make

sure hang track is level and mark the two separate hole and/or slot locations on the hang track where you will hit

studs. Use a #2 Phillips screwdriver to secure hang track to wall by attaching the two ST4.8 x 57 mm. pan head tapping

screws (II) and two M5 washers (JJ) through the hang track into the studs.

NOTE: Both screws must hit studs for hang track to be completely secured to wall. Do not use more than two screws.

Hook the exterior brackets on the hang track, and tilt the unit back and then down to hang unit.

*Please note location of predrilled holes on each part.

STEP 8b

x 2

#2 Phillips