Owner`s manual

MODEL CMA-180VL INSTALLATION & OPERATION Rev. 2.00 Page

a. After the machine has warmed up for five to ten minutes (5 – 10 min.), observe

the wash and rinse temperatures. The wash temperature must be 155°F

minimum. The rinse temperature must be 180°F minimum. If necessary, adjust

the temperatures by removing the panel in front of the respective heater and

turning the adjustment stem clockwise to increase.

NOTE: Rinse water temperature must be observed during the rinse cycle.

10. Check all water and drain fittings for leaks.

11. Install the wall chart and instruct the machine operator on the proper cleaning and

operation of the CMA-180VL.

Caution:

Booster heater is shipped on the dishmachine empty to prevent freezing. When the

machine is powered up for the first time, the booster heater must be filled immediately to

prevent damage to the heating element. See Section 2.2.7 (4d.)

Booster Heater

To prevent booster heater element damage, CMA has removed a wire from the high limit

switch. When initially filling of a newly installed dishmachine, you must fill the booster

tank prior to connecting the removed wire. When water is observed entering the wash tank

this indicates the booster tank is full and removed wire can be connected. Failure to follow

these important instructions will destroy the heating element because of dry -firing.