Owner`s manual
Operation
3. Operation
3.1. Initial Setup
3.1.1. Check…
Drain screen is in place
Spay arms and end plugs are secure
3.1.2. Chemicals
• Assure there is a sufficient supply of chemicals before beginning a shift.
3.1.3. Filling the Machine
• With the power ON, press and hold the Fill/Start switch in the “FILL” position
until the water level in the wash tank is about 1” deep, for best results use
water level indicator located at the back of the wash tank.
3.2. General
Caution: Do not operate the dishmachine without the drain screen in place. Debris
getting into the pump impeller can damage the pump.
1. Load a rack of properly pre-scrapped dished into the machine and close the door.
2. With the machine filled to the proper level, toggle the Fill/Start rocker switch to the
“START” position – the machine will automatically begin its cycle. The green running
light on the switch will illuminate while an operational cycle is in process.
3. At the end of the shift, drain the machine by holding the Drain rocker switch in the
“DRAIN” position until the machine is completely drained. To avoid running the pump
dry, do not hold the Drain rocker switch in the “DRAIN” position any longer than
necessary.
4. Remove and clean the drain screen. Remove and clean the spray arms. (See wall
chart instructions or instructions provided in Appendix A: Operator & Cleaning
Instructions).
5. Replace the drain screen and spray arms.
6. Inspect your dishmachine interior for lime deposits. If de-liming is required, a de-
liming agent should be used for best results in accordance with chemical supplier’s
instructions.
• Toggle De-lime switch to the “De-lime” position.
• Allow the machine to run for several minutes or until the interior lime build up
has been dissolved.
• Flip De-lime switch to the “Normal” position.
Warning:
Close the dishmachine door before activating the De-lime Switch. Skin
contact with de-liming solutions can cause severe irritation and possible burn. Always
wear protective clothing and goggles when handling chemicals. Contact your
chemical supplier for specific safety procedures for the use of de-liming solution.
MODEL L-1X & L-1X16 INSTALLATION & OPERATION MANUAL Rev. 1.16A Page
8