Parts Manual

Model CMA-180 Parts Manual Rev. 2.07B page 23
4. 180 Conversion Kit – Straight to Corner #00617.17
INSTRUCTIONS:
1. Open dishmachine door to its highest position so that there is
little spring resistance on the door handle. Remove hardware
that holds the door handle to the door linkage. Save all the
washers and spacers. Swing the door handle towards the
back of the dishmachine and dismount it from the door handle
support brackets. Remove the two nuts attaching the eyebolts
and save the door springs.
2. Remove the two (2) door-handle support brackets on the back
of the cabinet and plug the four holes with original hardware.
Remove front door and replace with left door. Remove door
guides on left side of machine and attaché item No. 9 door
panel-cover. The left door will now be at the front of the
machine. Remove and relocate service door splashguard to
left side of machine. Remove door latch for service door. The
door latch is not needed on the CMA 180-C.
3. With left door facing the front, door panel on the left, and
service door splashguard in place, we are now ready to install
the door handle.
4. Using provided door handle, door handle mounting plates,
5/16” bolts, nuts and washers; install the door handle as shown
in “Illustration #1”. Match the mounting plate holes to the
cabinet holes and insert all bolts to ensure that the door handle
and mounting plates are aligned. Then secure the mounting
plate with nuts and washers.
Note: You may install one of the mounting plates first, then insert
the door handle pivot post in and mount the other mounting plate
last.
5. Attach the provided extension rod to the back of the door
handle. Attach one eyebolt to the frame with existing
hardware, along with two springs together. Pivot the door
handle, positioning handle straight up. You may now connect
loop of 2
nd
spring to the door extension rod. Pull handles
forward and down and attach to the door links.
6. Adjust the nut on the eyebolt until the doors begin to lift then
back off two turns. See “Illustration #2” for proper location of
all door handle hardware included on CMA 180C.
7. “Illustration #3” shows CMA 180-S and CMA 180-C “Door
Handle Assembly”.
ILLUSTRATION #2
ITEM
NO.
NO.
REQ’D
P/N
DESCRIPTION
1
1
00613.04
Door Handle
2
1
00619.34
Door Hdl. Mtng. Plate-Long
2A
1
00619.44
Door Hdl. Mtng. Plate-Short
3
1
00603.04
Door Spring Extension
4
9
00913.00
5/16” – 18” Nut
5
9
00926.00
5/16” SS washer
6
1
00900.00
Cotter Pin
7
2
00607.04
Door Handle Grip
8
8
00920.00
5/16”-18 x ¾” Hex Head Bolt
9
1
17506.50
Door Panel-Cover
10
1
00563.20
Roller Switch Bracket
11
1
17507.10
Air Gap Baffle CMA 180C
ILLUSTRATION #3
Back View
Note: Door handle mounting plates come in two sizes.
Longer is mounted on back-right side.
ILLUSTRATION #1
Back View