Troubleshooting guide

23
FLOATING REMOTE DOESN’T WORK
Probable Cause Recommended action
Low battery power Replace with new batteries.
Programming of
remote is incorrect
Refer to remote control user’s
instructions included with your
spa.
RADIO/CD PLAYER
Problem Recommended action
If CD player doesn’t
read CDs:
•TryotherCDs.
•CleantheCDPlayerheads(by
using special cleaning CD).
•ReadtheSonyinstructionbook
provided to you.
DVD/CABLE
Problem Recommended action
No sound or video
when playing DVD or
watching CABLE
•IncreaseCDplayervolume.
•Inordertosettheaudiofor
DVD/CABLE, turn on the Radio/
CD player by pressing ON/OFF
button on oating remote
control. Press the button again to
switch to AUX (auxiliary input).
•CheckfortheblownLCDMonitor
FUSE5A(fuse#1).
•VerifythatMonitormodeisat
Video (DVD).
•OrverifythatMonitormodeisat
TV (Cable).
•MakesuretheDVDvideodisc
works with sound/video in other
DVD players.
•MakesurethemonitorisON.
•VerifythattheStereoisNOTon
ATT.
LCD MONITOR
Problem Recommended action
No power
•Checkforblown5Afuse.Fuse#1
in the fuse box.
•UsingMonitor’soriginalremote
control, press ON/O button,
being sure to hold the controller
very close to the screen (within
four inches).
LCD Monitor doesn’t
respond to oating
remote control or
B.O.S.S.
•Reprogramtheoatingremote
control. Follow instructions on
how to program oating remote
control or B.O.S.S.
No sound
•Increasevolumeonyourstereo
with either oating remote
control or manually.
•WithoriginalLCDMonitor
remote control, press Volume
Up button, being sure to hold
the controller very close to
the screen (within four inches)
until you see volume bar on
the screen led to Maximum.
Repeat with original DVD remote
control.
•TurnontheRadio/CDplayer
by pressing ON/OFF button on
oating remote control; press the
button again to switch to AUX
(auxiliary input).
No picture
•CheckifDVDispoweredON.
•CheckifMonitorispoweredON.
•Onyouroatingremote,press
TVthenPLAYbuttonuntil
display message on your monitor
shows VIDEO mode.
•Tryanotherchannelorinput
source.
•ApplyFactorysetupwiththe
original Monitor’s remote; refer
to page 13 of LCD Monitor’s
owner’s manual. Be sure to hold
the controller very close to the
screen (within four inches).
Only snow appears on
the screen
•CheckCable/TVconnection;refer
to the stereo enclosure image
shown in this manual.
•WithoriginalMonitor’sremote,
press Auto Scan button. Be sure
to hold the controller very close
to the screen (within four inches).
AMPLIFIER
Problem Recommended action
Subwoofer
doesn’t work
•Checkforblown20Aamplier
fuse (in the amplier).
•AdjustBasssetting.RefertoCD
player user’s manual.