Troubleshooting guide

24
INTERNATIONAL CUSTOMERS
AUDIO/VISUAL TROUBLESHOOTING
Problem Recommended action
There’s no picture
•RefertoLCDMonitor
troubleshooting presented in
this guide.
•UsingMonitor’soriginalremote,
press SOURCE button, being sure
to hold the controller very close
to the screen (within four inches)
until display message on your
monitor shows VIDEO.
Notes
There’s no sound
when watching
Cable/TV
•WithMonitor’soriginalremote
control, press Volume UP button
until you see the volume bar
lled up to maximum.
•RepeatwithDVDremotecontrol.
•TurnONtheModulatorSwitch
found on the right side of the
DVD Player and set the Radio to
89.1 FM.
•ChecktheModulatorFuse5A(#4
in the fuse box).
DVD will not play
•There’snodiscinside(NODISC
message appears on the front of
the DVD Player).
•VerifythatMonitormodeisat
Video (DVD).
•MakesuretheDVDvideodisc
works with sound/video in other
DVD players.
•MakesurethemonitorisON.
•CheckfortheblownLCDMonitor
FUSE5A(fuse#1).
•DiscisupsidedowninDVD
Player. Insert disc correctly, with
label side up on disc tray.
•Thedischasbeendamaged.
Change the disc.
•Moisturehascondensedinside
the player. Remove disc and
leave the player turned on for
one hour.
The remote doesn’t
function
•Removealltheobstaclesfrom
the path of the IR remote sensor.
•PointtheremoteattheIRsensor
on the DVD Player.
•Replacethebatteriesinthe
remote.
B.O.S.S.
Problem Recommended action
If B.O.S.S. loses
communication:
Youhavetoforcetheremoteto
synchronize as follows:
•Holdthetwobottomkeys
for 10 seconds (when the
communication error message is
displayed)
•Pressonthesyncmenu
•Alignremotetocradlefor
synchronization
If B.O.S.S. remote
does not respond:
•Puttheremoteinthecradle
and leave it there for
24 hours to charge
•PressonHOME-NEXT-OPTIONS
- SLEEP - answer ‘yes’
•Inserttheremoteinside
the cradle
•Spashouldthenfunction