User`s guide

142 Adept Cobra PLC600/PLC800 Robot User’s Guide, Rev C
Figure 7-4. Solenoid Mounting Bracket With Connector and Spare Air Line
4. Cut and discard the tie-wraps holding the spare air line at the top of the mounting
bracket. Move the air line away to facilitate the mounting of the solenoid
manifold (see Figure 7-4).
5. Mount the solenoid manifold onto the bracket using the supplied M3 x 25 mm
screws and washers (see Figure 7-5 on page 143).
6. Insert the spare air line into the air intake coupling of the solenoid manifold.
Make sure the air line is pushed in all the way and secured in place by the intake
coupling. Confirm by pulling the air line.
7. Plug the connector plug into the female connector jack (marked SOLND) on the
bracket.
8. Use tie-wraps to secure air line to the bracket as needed.
Pem nuts to mount the
solenoid manifold
Connector for the
solenoid valves
Spare air line