User`s guide

Adept Cobra PLC600/PLC800 Robot User’s Guide, Rev C 45
Table Mounting the PLC Server
To table mount the PLC Server, install two brackets on each side near the bottom of the
unit, as shown in Figure 3-5. Use the screws from the accessories kit.
Figure 3-5. Table Mounting the PLC Server
CompactFlash Memory Card
The PLC Server is equipped with a CompactFlash™ (CF) memory card. The PLC Server
system uses a CF in place of a traditional hard disk drive. In fact, it is often referred to as a
“solid state hard drive”. The CF is about half the size of a credit card and twice as thick. It
has no moving parts and is therefore reliable and durable.
The CF shipped with all systems has a capacity of 30 MB and is factory configured by
Adept. The CF stores the PLC Server software.
NOTE: Adept reserves the right to increase the size of the standard CF
without notice.
Not all types of CompactFlash are compatible with the PLC Server. Adept requires the use
of the CF supplied by Adept at the time of the PLC Server purchase and that all
replacement CF cards be obtained from Adept.
CAUTION: Use suitable measures for eliminating
electrostatic discharge during handling of the
CompactFlash. This includes, but is not limited to, the use
of a grounded wrist strap while performing this operation.
21.6
12.1
29.5
16.2
120.9
16.0
R 3.6
378.6
24.1
4X 40356-00001
24.9
4X M3 x 6MM
BOTH SIDES
391.8
120.9