User manual

12
2-4. Purchased X30 without storage.
You need a 3.5” or 2.5” SATA hard disk or SSD, and install it into the X30 like below picture and
format it. For formatting of the installed storage into X30, please refer to the 5-7-6. HDD format.
2-4-1. HDD installation
【 TIP 1 】 X30 supports 3.5” or 2.5” SATA hard disk and solid state drive (SSD)
2-4-2. HDD Format
※ Refer to the 5-7-6. HDD Format
2-5. Purchased X30 with an internal storage installed.
Check whether the storage is formatted, or not. If the storage is not formatted, please format it
according to the 5-7-6. HDD Format.
3. Connection
3-1. Power connection
Connect power to the X30 via the power inlet and switch on the rear of the X30.
3-2. External devices Connection
Refer to the rear view on page 9. Various devices can be connected to X30 like below according
to your purpose.
 Speaker Out terminal(8ohm) : Bookshelf speaker or floor standing (power load) speakers
 Digital Out (Toslink, Coaxial, AES/EBU XLR) : External DAC, etc
 Analog Out(RCA, R/L) : External amplifier, etc
 FM Radio Antenna connector : FM Radio antenna
 USB Host ports: WiFi USB dongle, external USB devices, etc
 HDMI Out : External screen like TV, etc