MICRO-USB RCD2002 1x 1x A sold separately B MN160080_20170111 QR rtube.nl/red698 Coulisse B.V.
A B W F = W-137/64 in F = W-137/64 in W Min. W = 18 1/2"” Min. W = 18 1/2"” 1 2 W F = W-137/64 in F 3 F 37 /64 in 4 MN160080_20170111 5 Coulisse B.V.
A B 1 W Click! 2 MN160080_20170111 3 4 Coulisse B.V.
5 6 7 Charge to activate the motor Charge before first use. (motor can be used during charging) See step 20 MN160080_20170111 8 Coulisse B.V.
9 Save bottom limit Pull and hold the wand until the blind has reached the bottom limit. If the blind moves in the opposite direction release the wand and pull and hold again. Adjust until the desired bottom limit has been reached Save the position by holding the button until the blind moves up and down 10 11 Save upper limit Pull and hold the wand until the blind has reached the upper limit. If the blind moves in the opposite direction release the wand and pull and hold again.
Operating the blind 14 Set the blind to your favorite position 15 Optional : Save the favorite position Pull the wand shortly to start or stop the blind. Pull and hold the wand for approximately 7 second until the blind moves up and down MN160080_20170111 13 Coulisse B.V.
16 Go to any position other than the saved favorite position 17 Operate to favorite position Hold the wand for 5 seconds The blind moves to the favorite postion 18 Delete favorite position Pull and hold the wand for approximately 7 second until the blind moves up and down MN160080_20170111 Go to step 14 to program a new favorite position Coulisse B.V.
19 Hold the button for approximately 10 seconds, the blind will move up and down two times. Delete end limits Repeat steps 9 - 12 to save new end limits 20 Charging blinking green ; battery is charging Continuously green ; battery is fully charged MN160080_20170111 Blinking red during operation ; Charge the battery Use a Micro-USB cable Coulisse B.V.
