Service manual

ManualsBrandsCode 3 ManualsAutomotiveSuperVisor

Read all instructions and warnings before installing and using.

This manual must be delivered to the end user of this equipment.

IMPORTANT:

CONTENTS:

For future reference record your product's serial no. here __________________________________________

INSTALLER:

SuperVisor™ with TriCore™ Technology

U.S. Patent Nos. 7,153,015 and 7,300,175, Other Patents Pending

Interior Lighting System

Ford Crown Victoria

INSTALLATION

& OPERATION

MANUAL

SuperVisor™

Introduction ...........................................................................2

Unpacking & Pre-Installation ................................................2

Installation & Mounting ......................................................3-4

Wiring Instructions - Flash Pattern Selection ....................5-6

Troubleshooting - Exploded View - Parts List .......................7

Warranty ...............................................................................8

Summary of content (8 pages)

PAGE 1
INSTALLATION & OPERATION MANUAL SuperVisor™ SuperVisor™ with TriCore™ Technology U.S. Patent Nos. 7,153,015 and 7,300,175, Other Patents Pending Interior Lighting System Ford Crown Victoria CONTENTS: Introduction............................................................................2 Unpacking & Pre-Installation.................................................2 Installation & Mounting.......................................................3-4 Wiring Instructions - Flash Pattern Selection .............
PAGE 2
Introduction The SuperVisor™ with TriCore Technology is an interior lighting system that fits in the visor area near the top of the windshield. The SuperVisor has room for up to eight TriCore lightheads. warning! The use of this or any warning device does not ensure that all drivers can or will observe or react to an emergency warning signal. Never take the right-of-way for granted.
PAGE 3
Installation Instructions Step 1-Removing Sun Visors Begin the installation by removing the Crown Victoria's driver and passenger sun visors. Identify each visor with tape or other marking to indicate the driver from the passenger side unit; they are not identical. There are three screws that hold the pivotal arm of the sun visor to the headliner. Remove each screw using a small #20 torx screwdriver starting with the lower screw as shown in Figure 1.
PAGE 4
Installation Instructions Cont. Step 5 Mounting the SuperVisor™ Once all four brackets and sun visors are attached, the SuperVisor is now ready to be installed. Rotate the rear view mirror down as far out of the way as possible.
PAGE 5
Wiring Instructions Larger wires and tight connections will provide longer service life for components. For high current wires it is highly recommended that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation displacement connectors (e.g. 3M® Scotchlock type connectors). Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce voltage drop. High ambient temperatures (e.g.
PAGE 6
Wiring Diagram and Flash Pattern Changes - WITH TAKEDOWNS NOTE: FOR SUPERVISORS WITH TAKE DOWN OPTION CONTROL WIRES ARE AS SHOWN BELOW THE TAKEDOWN STEADY(YELLOW) WIRE WILL OVERRIDE THE TAKEDOWN FLASH (ORANGE) WIRE. BLACK (GND) BLUE (LEVEL 1) ORANGE (TAKEDOWN FLASH) YELLOW (TAKEDOWN STEADY) RED (POWER) WHITE (DIMMING) GREEN (PATTERN SELECT) TriCore Takedown Flash Pattern Selecting Flash Patterns: The Takedown Lights can be programmed to flash at different rates. STEP 1: Power-up the lightbar.
PAGE 7
Troubleshooting All SuperVisors are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life of the product, follow the guide below for information on repair and troubleshooting. Additional information may be obtained from the factory technical help line at 314-996-2800. Follow the guide below for information on repair and troubleshooting. TROUBLESHOOTING GUIDE Note: TriCore Modules must be replaced as a module. There are no user serviceable parts.
PAGE 8
WARRANTY This product with TriCore™ Technology was tested and found to be operational at the time of manufacture. Provided this product is installed and operated in accordance with the manufacturer's recommendations, Code 3®, Inc. warrants all parts and components (with the exception of all incandescent and halogen bulbs) of the product to be free of defects in material and workmanship for a period of one (1) year and TriCore light heads for a period of five (5) years from the date of purchase.