PROFESSIONAL SERIES CA 5051 Owner’s Guide Remote Start and Keyless Entry System IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. 2010 Audiovox Electronics Corporation. All rights reserved.
Table of Contents Using Your Remote Control ............................................................... 3 Using the Keyless Entry ................................................................... 3 Two Stage Door Unlock (optional) ................................................... 3 Activating Trunk Release (optional) ................................................ 3 Using the Progressive Car Finder Feature ...................................... 3 Using the Personal Protection Alarm ...............
Using Your Remote Control Using the Keyless Entry The button is used to lock the vehicle's doors, the button is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release the desired function button one time. For your convenience, the parking lights will flash once when the doors are unlocked and twice when the door are locked.
Valet Mode Valet Mode is used to disable the system from remote starting. To enter or exit valet mode simply follow the 4 steps outlined below: 1. Turn the vehicle’s ignition ON. 2. Push and hold the programming/valet button. 3. The LED will turn on solid when valet mode is active 4. Release the programming/valet button. Eliminating Lock / Unlock Notification Chirps System lock and unlock notification chirps can be toggled ON or OFF without entering the programming feature banks. 1.
Preheating or Precooling the Vehicle’s interior Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the vehicle, the heater or air conditioner will activate and heat or cool the vehicle’s interior to your setting. User Programmable Run Time / Run Time Extension The system has the ability to allow the user to extend the time the vehicle will be running under control of the remote start.
To begin the 2 / 3 hour start up timer mode: 1. Turn the vehicle’s ignition ON then OFF. 2. Press and hold the valet button. 3. Press the 4. button 4 times, the system will; a. When set for 3 Hour (default) - chirp 2 times and flash the parking lights 4 times. b. When set for 2 Hour - chirp 1 time and flash the parking lights 2 times. Release the valet button. To exit the 2 / 3 hour start up timer mode: 1. Turn the vehicle’s Ignition ON. OR 1.
Transmitter Button Functions 1 Way Transmitter Lock Lock Unlock Car Find / Panic Start X Operation Method Press and Release Unlock X Trunk X Press and Release Push and Hold (3 Sec) Car Finder X Panic X Press and Release Push and Hold (3 Sec) Remote Start X Press and Release (1 or 2 times depending on selectable option) Remote Start Shut Down X Push and Hold (3 Sec) Run Time Extention X Press and Release 4 times.
Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc.
2010 Audiovox Electronics Corporation. All rights reserved.
Audiovox Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation.