Installation guide

5
LT
GREEN/BLACK
FACTORY DISARM
I
PULSE
BEFORE
START
(
- )
This wire
will supply
a
(-)
200mA pulse
both upon disarming the system and when
the remote start feature is activated. Locate the factory perimeter alarm
disarm wire
from the key
cylinder
inside the drivers door.
Verification:
This wire registers ground if the key is turned to the unlock
position in the driver's door
cylinder.
Connect the
LIGHT
GREEN/BLACK wire to the factory
alarm
disarm wire.
6
ORANGE GROUND WHEN ARMED OUTPUT ( - )
This wire
will
have a continuous
(-)
500mA
output when the system
is
Armed.
This wire is
typically
used for
controlling
the starter interrupt relay
as
well
as window
modules
or
additional
sensors.
This output can be configured
in
option programming.
1
BLUE/WHITE INSTANT TRIGGER INPUT ( - )
This wire is a
GROUND
input for
an
external
sensor or secondary pin switch.
Verification:
This wire when connected
will
trigger the security system.
2
GREEN
DOOR TRIGGER INPUT
(-)
Locate the
vehicle's dome light
or door pin switch wire.
Verification:
This wire
will
register ground (NEG) when the door
is
opened
and the interior
light
is on. This wire
will register positive
voltage
when the
door is
closed
and the interior
light
is off.
Connect the GREEN wire to the
vehicle's negative door input wire(s).
NOTE:
Certain
vehicles may require
multiple
connections. Refer to vehicle
application
guide.
2014 Voxx
Electronics
Corporation.
All rights reserved.
11