Installation guide

14
4 Pin Alternate Output Harness
1
L T GREEN/BLACK
FACTORY DISARM
I
PULSE
BEFORE
START
(
- )
This wire
will supply a ( - )
200mA
pulse both upon disarming the system and when
the remote start feature is activated. Locate the factory perimeter alarm disarm wire
from the key cylinder inside the drivers door.
Verification: This wire registers ground if the key
is
turned to the unlock
position in the driver's door cylinder.
This output can be configured
in
option programming.
2
LT
BLUE
FACTORY ARM
I
PULSE
AFTER START
( - )
This wire
will supply a
( - ) 200mA pulse both upon arming the system and upon
successful completion
of
the remote start activation sequence and is typically used to
re-lock the vehicle's doors upon remote start if necessary.
This output can be configured
in
option programming.
3
GREEN/WHITE
PULSE
AFTER
SHUTDOWN
(
- )
This wire will
supply a
( - )
200mA
pulse after the remote start shuts down. This
is
typically used to re-lock the vehicle's doors if they unlock upon remote start
shutdown. It can also be used to pulse a door pin-switch wire to prevent the vehicle's
accessories from remaining on after remote start shutdown.
This output can be configured
in
option programming.
4
BLACK/YELLOW
PULSE DURING CRANK
(
- )
Locate the vehicle's second starter (crank) wire at the ignition switch. (if equipped)
Verification: This wire registers voltage only
in
the start (crank) position
of
the ignition switch.
This wire
will
supply a ( - )
200mA
output and can be configured in option
programming.
ca6554 Install revA