Installation guide

20
Additional Ports
Antenna
I
LED
I
Programming Port
Mount the
supplied antenna/receiver to a clear
spot on the
vehicle's windshield that
will
not
block the driver's vision. A good location
is usually
high on the
windshield
near the rear view mirror. Be careful not to mount the antenna/receiver
on
any
metallic
window
film,
as this
will
effect system range. Route the antenna/receiver
cable to the control module
and
plug
into the antenna port.
Data Bus Interface Port
This 4 pin port is used for
Flashlogic
Door Lock and Transponder Databus
Interfaces
to communicate with the
vehicle's
Databus. When using the DBI port to
control the
Flashlogic
Door Lock and Transponder Interface modules the
following options may
be
available. Please
refer to the D2D (Data to Data) function
list available
per
vehicle
on the tech service web site.
Tach Input
Door Trigger
Brake Safety Shut Down
Trunk/Hatch Open
Door Lock Control
Dome Light Supervision
Factory
Alarm
Arm
I
Disarm
Passlock
I
Passkey Interface
(GM
Only)
Transponder
Interface
Activation
Diesel Glow Plug Input
Manual
Arm
I
Disarm
Inputs
(factory keyless controls
system)
Telematic Interface Port
This 4 pin port is used for
telematic Interface
accessories, such as Car Connection
Pro, which can
control
some
of
the
following
features.
Door Lock
Control Trunk
Release
Sliding
Doors AUX Output
Car Find Remote Start
ca6554
Install
revA