Installation guide

Feature Bank 4 - Remote Start Control
1 ·
RF
Start
Chirp: Turns remote start activation confirmation chirps
ON
or
OFF.
2
• Run Time: Controls the time
in
minutes that the vehicle will
stay running under
control of the remote start until the system times out. The system may also be shut
down at any time by use
of
the transmitter or system shutdowns.
3
• Running Lights: Controls the
WHITE
parking light output wire during remote
start.
Steady - Parking lights constant during the remote start
cycle.
Flashing - Parking lights flash at a slow pace during the remote start cycle.
4
·
Tach Mode: Determines how the system monitors the engine running during
remote start.
Tach
- Hard wired directly to the tach wire of the vehicle to monitor
AC
voltage.
Tach
less (Crank Average/Voltage) - Determines crank time by averaging the
last 8 times the vehicle was started with the key and then monitors the
change
in
voltage after remote start.
Hybrid (Crank Average
I
No Voltage)- Determines crank time by averaging
the last 8 times the vehicle was started with the
key.
OBI
Port-
Monitors the vehicle's tach rate through an interface module
connected to the
OBI
port.
5
·Voltage Level:
The voltage variance for remote start when set to tachless. (see
tach mode)
HIGH-
The variance
in
battery voltage from before the remote start
is activated to after the engine is running must
be
greater than
0.5
volts.
LOW - The variance
in
battery voltage from before the remote start
is activated to after the engine
is
running may
be
less than
0.5
volts.
6
•
Crank Time: Preset output times for the PURPLE starter wire.
7
•
Crank Average
I
Crank Time: The length of time
in
which the remote start
will
crank the vehicle's starter.
Crank Average - Determines crank time by averaging the last 8
times the
vehicle was started with the
key.
Preset
Time-
Preset starter output time. (see crank time)
2014 Voxx Electronics Corporation.
All rights reserved.
31