Installation guide

Using the Progressive Car Finder Feature
Press the ~>)) button to locate your vehicle. The system will flash the parking lights
and sound 5 times at low volume, increasing
in volume each time the button is
pressed.
Using the Personal Protection Alarm (Panic)
Press and hold the ~>)) button for 3 seconds to activate the personal protection alarm.
During panic mode, the normal function
of the transmitter buttons will be suspended.
The transmitter's
@ and riJ buttons can be used to lock and unlock the door (if the
option is installed).
To stop the alarm, press and hold the ~>)) button on the transmitter
again for 3 seconds. The system will automatically stop after 30 seconds.
Programmed Transmitter Notification
As a security precaution each time the vehicle's ignition is turn on the status LED
light with flash the number
of transmitters programmed into the system. This helps
to identify unauthorized transmitters from accessing your vehicle. If you believe
an
unauthorized transmitter has been programmed to your system, contact your installing
dealer for assistance.
Valet Mode
When valet mode is activated the status LED will light solid, and all security
functions will
be disabled. To enter or exit valet mode simply follow the 4 steps
outlined below:
1. Turn the vehicle's ignition ON.
2. Push and hold the programming/valet button.
3. The LED will turn on solid when valet mode is active
4. Release the programming/valet button.
Eliminating Arm I Disarm Notification Chirps
System ARM/DISARM chirps can be toggled ON or OFF without entering the
programming feature banks.
1. Turn the ignition ON then OFF.
2. Press and release the valeUprogramming button 3 times. The system
will respond with 1 chirp for
ON or 2 chirps for OFF.
2014 Voxx Electronics Corporation. All rights reserved.
5