Installation guide

Remote
Start
Ready Mode
must
be enabled
if
your
vehicle
is
equipped with a
manual transmission.
Remote
Start
Ready Mode - Manual Transmission Vehicles
Only
To
activate
the
remote start function, the system must first be
in
Remote
Start
Ready
Mode. Follow
the steps below to enter remote start ready mode.
1.
While the engine is running by the ignition key;
a.
Set
the parking brake
b. Place the transmission
in
neutral.
2.
With your foot off the brake pedal, press and release the
0
button 2
times within 2 seconds. The LED
will
flash 3 times and the parking
lights will
turn on to confirm the system has entered quick stop mode.
3.
Remove the keys from the ignition, the vehicle
will
remain running in
quick stop mode.
4.
Exit the vehicle and close
all
vehicle doors.
5.
Within 1 minute
of
step
1,
press the
@
button to lock the vehicle's
doors. The vehicle will
shutdown and sound 2 short chirps then 1 long
chirp to confirm ready mode is set.
Cancelling Remote Start Ready Mode
The system
will
exit remote start ready mode if any
of
the
following
occur:
Open
any door
Open
the hood
or
trunk (if connected)
Press the brake
Release the parking brake
Turn the ignition
ON
2014 Voxx Electronics Corporation.
All
rights reserved.
7