Installation guide

Additional
2-Way
LCD. Remote
Control Functions
Check Vehicle Status
Press and release
rF
2 times then press
@
within 3 seconds, the transmitter
will
display
the current status
of
the vehicle.
Display
Illumination
Press and
hold
the
rF
button for 1 second. The display will illuminate
for 5
seconds.
Melody
I
Vibration Mode
To
have the remote
control vibrate, play a melody
tone or both each time it receives a
response from the
vehicle
press and release
rF
then press and
hold
~
for 2
seconds.
Button
Beeps
To
toggle
button beeps on or off press and
release
[F
then press and
hold 0
for 2
seconds.
Battery
Save Mode
While
in
POWER SAVE MODE the 2-way
LCD
transmitter
will NOT look
for any
incoming
signals from the main unit
until a button
is
pressed. The
LCD screen
will
display SAVE
to indicate that power save mode is
ON.
To
enter power save mode
press and
hold
[F
for 5 seconds.
In Clear Flashing Icons
and
Melody
Sound
Press the
[F
button 3 times within 3 seconds. This
will clear
the melody
sound and
flashing icons on the
LCD screen .
•
~.~~
Stopping
LCD Trigger Melody
To
stop the
alarm
trigger
melody
if
the system has been triggered
WITHOUT
disarming the system, press any button one time
only,
this
will
not send a command to
the vehicle
at this time and the
alarm will
continue to sound.
2014 Voxx Electronics
Corporation.
All
rights reserved.
13