Installation guide

4
Pln
Mail"l
Harness
1
WHITE/RED PARKING LIGHT INPUT
2
WHITE PARKING LIGHT OUTPUT
Locate the parking
light output wire at the
vehicle's light switch.
Verification:
This wire registers positive voltage
when the parking
lights
are
turned on.
Positive switching Parking Lights:
Connect the
WHITE/RED
wire to a
15
Amp max fused battery source.
Connect the WHITE
wire to the parking light output wire.
Negative switching Parking Lights:
3
Connect the
WHITE/RED wire to a good chassis ground.
Connect the
WHITE
wire to the parking
light output wire.
BLACK
GROUND
Connect the BLACK wire to a
solid
chassis ground point using a ring
terminal
and
self tapping screw (not
supplied).
Scrape away paint from the grounding point to
ensure a good connection. The recommended grounding point is a metal
surface
in
the driver's side kick panel
area.
NOTE:
Do not ground the BLACK wire with any other
vehicle
components.
4
BROWN
SIREN
OUTPUT (
+)
Locate a suitable
mounting
location
in
the engine compartment for the siren, away
from moving parts.
With the
bell
of the siren aiming downwards, secure the siren
in
place using
self
tapping screws, being
careful
not do drill
into any hoses, wiring or components.
Connect the BLACK siren wire to a chassis ground using a ring terminal
and
self
tapping screw (not
supplied).
Route the BROWN siren output wire from the
control module
through the
firewall
and
connect to the RED wire on the siren.
NOTE:
Be sure to
loom the siren wires, and
seal the grommet.
2014
Voxx
Electronics
Corporation.
All rights reserved.
7