Installation guide
8
1 PURPLE
STARTER OUTPUT ( + )
Locate the vehicle starter wire.
Verification: This wire registers voltage only when the key is turned to
the
START position. Cut the vehicle's starter wire
in
half when installing
the
starter kill relay.
Verification after starter wire is cut:
KEY SIDE
of
starter wire registers voltage when the key is turned to
the
START position.
MOTOR SIDE
of
starter wire registers no voltage.
Connect the PURPLE wire to the vehicle starter wire, use the MOTOR SIDE
of
the
vehicle starter wire when installing the starter kill relay.
2
RED
BATTERY 12V (
+)
Locate 1
of
the vehicle's constant 12 Volt battery wires at the ignition switch.
Verification: This wire will register ( + ) voltage
in
all positions
of
the ignition
switch.
Connect the RED wire to the constant 12 Volt battery wire.
NOTE: Remove all fuses until all connections are made.
3 ORANGE
ACCESSORY 1 ( + )
Locate the vehicle's accessory wire at the ignition switch.
Verification: This wire registers voltage when the key is turned to
ACC
(Accessory) and the ON (or RUN) position. The voltage drops out
when
the
key is turned to the START (or CRANK) position.
Connect the ORANGE wire to the vehicle's accessory wire.
ca6554 Install revA