Installation guide

4
PINK/WHITE
IGNITION
2
( + )
Locate the vehicle's 2nd ignition wire at the ignition switch (if equipped).
Verification:
This wire registers voltage when the key is turned to the
ON
(or
RUN) position, but not the
ACC
(Accessory) position. The voltage does not
drop out when the key is turned to the START (or CRANK) position.
Connect the
PINK/WHITE wire to the vehicle's ignition 2 wire.
Programmable output:
IGN,
ACC,
Start.
5
RED/WHITE BATTERY 12V (
+)
Locate 1
of
the vehicle's constant 12 Volt battery wires at the ignition switch.
Verification:
This wire
will
register ( + ) voltage
in
all positions
of
the ignition
switch.
Connect the RED/WHITE wire to the constant 12 Volt battery wire.
NOTE: Remove
all
fuses
until all connections are made.
6
PINK IGNITION 1 (
+)
Locate the vehicle's ignition wire at the ignition switch.
Verification:
This wire registers voltage when the key is turned to the
ON
(or
RUN) position. The voltage does not drop out when the key
is
turned to the
START (or CRANK) position.
Connect the
PINK
wire to the vehicle's
Ignition
wire.
This wire is also
used for
Ignition
1
Output.
2014
Voxx Electronics
Corporation.
All
rights reserved.
9