Technical data

Repair
14 312185S
7. Remove the retaining ring (1) from the back of the
air cylinder (2). Push the two shafts (5) into the air
cylinder (2) to dislodge the air cylinder cap (22). See
F
IG. 6.
8. Push the two shafts (5) to dislodge the piston (9)
assembly from the air cylinder (2).
9. Use an o-ring pick to remove the o-rings (23) and
use a screwdriver to remove the sleeve bearings (7)
from the air cylinder (2).
10. Remove the o-rings (6) from the piston (9) and air
cylinder cap (22).
11. Remove the screw (24) and snuff-back adjustment
knob (21) from the cap (22). Use an o-ring pick to
remove the o-ring (23).
12. Remove the lock nuts (3), the pin (8), o-rings (4),
and piston o-ring (6) from the shaft (5).
Pneumatic Handle (if equipped)
1. Remove the four screws (214). Pull the handle (205)
and gasket (204) away from the air cylinder (2).
2. Unscrew air valve plug (211) and remove spring
(213). Using a small diameter tool, push spool (202)
out from front. Inspect o-rings (203).
Electric Switch Handle (if equipped)
1. Disconnect the power from the gun.
2. The switch and cable are not repairable. Replace
these parts as a complete assembly. Use kit 255463
for series A handles. Use kit 24D049 for series B
handles.
3. Loosen the relief connector (112) and remove the
air valve plug (111).
4. Remove the wire which will take the electric
switch (114) and spacer (115) with it.
F
IG. 6
23
7
5
8
6
9
4
3
22
6
1
24
23
21
39
TI9975B
2
FIG. 7
F
IG. 8
202
203
213
211
203
TI10408A
204
212
210
214
206
201
205
104
101
113
116
114
115
111
112
TI10384B
120