User`s manual

EP -1000 Instant Dry Imager User’s Manual xiii
Preface
Unsuitable Materials for the Imager
Many plastic components are used in the imager’s construction.
Coat flecking and deformation is likely to occur if the imager is
wiped with chemical dusters, benzene, thinners, insecticides or
other solvents. Rubber and PVC materials left in contact with the
imager for extended times will cause damage. Never use
petroleum-based solutions or abrasive cleaners.
Thermal Print Head Abrasion
The thermal print head will wear. When it is abraded, it becomes
difficult to print fine details. In such a case it is necessary to replace
the thermal print head. Contact your service representative for
assistance.
Product Cautions
This product will not cause any special health or safety hazard
when used as intended. Spent media can be disposed in accordance
with local, state, or federal regulations.
Packaging
Use the original packaging when shipment of the product is
necessary. This packaging has been designed to minimize possible
damage during shipment.