User`s manual

EP -1000 Instant Dry Imager User’s Manual 2-9
Setting Up the EP-1000
1. Make sure that your computer is turned off.
2. Connect the female end (no pins) of the cable to the EP-1000
parallel port.
3. Connect the 25-pin end of the cable to the computer’s parallel
port.
4. Connect the power cord.
5. Press the
Power button to power on the EP-1000.
6. Press the
Online button to set the EP-1000 to offline mode.
7. Press the Interface button so that the Parallel light flashes.
8. Press the
Online button to set the EP-1000 to online mode.
The Parallel light comes on steady (stops flashing).
Connecting a Parallel Cable
8
To connect a
parallel
(Centronics)
cable
Power cord
connector
Parallel
port