User`s manual

EP -1000 Instant Dry Imager User’s Manual 2-17
Setting Up the EP-1000
When you power on the EP-1000, it initializes (starts up and
performs a self-check) in a few seconds. During this time, the Fault,
Media , Parallel , and USB lights flash.
If the EP-1000 fails to initialize, none of the lights on the display
panel will flash. Power off the EP-1000, then power it back on.
If the lights do not flash after powering on again, power off both
the EP-1000 and the host computer. Disconnect all cables from the
EP-1000 except the power cable. Power on the EP-1000 again. If the
lights on the display panel still do not flash, call Codonics Technical
Support for service.
Making a test print verifies proper EP-1000 setup and operation,
and confirms print quality.
1. Press the Power button while holding the Online button.
2. Press the
Print button.
The test print prints.
3. After printing, press the Online button.
4. Select the desired interface, then press the
Online button again.
The imager is now ready for normal printing.
An example test print is shown on the next page.
About Imager Initialization
Making a Test Print
8
To make a test
print