User`s manual

-1000

Instant Dry Imager User’s Manual

5-13

Troubleshooting

•

Wipe only the areas shown in the following figure.

3. Allow the wiped area to dry for about 2 minutes.

4. Close the top cover, and power on the imager.

5. Make a test print. If image artifacts are visible on the test print,

repeat this cleaning procedure.

NOTE:

It may be necessary to repeat the cleaning procedure several times to remove all

artifacts. If you cannot remove the artifacts, call Codonics Technical Support for service.

Guide bar

Heater line

Cover head