User manual
Table Of Contents
- Cover
- Title Page
- Table of Contents
- List of Tables
- List of Figures
- Preface
- Software Installation
- U.S. Export ControlLaws Compliance
- Publication Updates
- Symbols Used in This Document
- Safety
- Quick Start
- Description
- Operation
- Special Topics
- Host Interface
- Calibration and Warranty
- Appendix A: Specifications
- Index
FieldMaxII-TO User Manual
14
Left Side
Panel
The left side panel contains the Analog Out and Power
Jack connectors (refer to Figure 5).
Analog Out
Connector
When power is on, the Analog Out connector outputs a
voltage proportional to the current laser measurement.
The output voltage is zero (0) volts when the measured
power is zero (0) or less. The output voltage is the
full-scale output voltage when the measured power is
full-scale or overranged. The full-scale output voltage
(1V, 2V, or 5V) is selected via the host interface. Factory
default full-scale output voltage is 2V.
Power Jack
Connector
Connect the supplied power cord to this jack.
Figure 5. Left Side Panel
Power Jack Connecto
r
Analog Out Connector