User manual

FieldMaxII-TO User Manual
26
As an example, “Er 4” appears on the display if there is
a sensor error. You can dismiss the fault by removing the
sensor from the meter, or by pressing any button.
Attaching an unrecognized sensor to the meter creates a
special fault condition. This condition is characterized by
displaying a sensor fault (1 through 5).
Invalid and
Not Available
Data
Conditions
The update rate for invalid or not available data condi-
tions is three times per second.
Invalid Data
Invalid data is obtained whenever the meter over-ranges.
When invalid data is sensed, the letters “OL” (overload)
appear on the display. If “OL” appears while in Auto
mode, no further action needs to be taken. If “OL”
appears while in Manual mode, start a new batch by
pressing the Zero button. All data used to generate a
batch result must be valid.
Not Available
Data
Measurement data may be unavailable at certain times
during meter operation. When data is not available, a
series of dashes appears in the measurement area of the
display. The following condition will generate unavail-
able data:
• Statistics mode is entered and batch data has not
been compiled.