Use and Care Manual

When you are done using the outlet(s) and USB port(s), press the
button again to turn them off. This will keep the internal battery from
passively draining.
Additionally, when an output is not used for more than five hours it
will automatically turn off to conserve battery power. To bypass this
feature, please see “Power-Save Off” section on next page.
Conserving Battery Power
You can power and charge several items at once using any
combination of available AC/12V outlets and USB ports, as long
as the total combined power draw of all connected items does
not exceed the rated Output Power.
Please note: The more items that are connected, the faster your
Battery Generator will consume its available battery power and
needs to be recharged.
Connecting Multiple Items
Using your Battery Generator
Each output type (USB, AC, DC) has a separate power button with an indicator light to show that it is on. When any port is on the intelligent LCD screen will also turn on.
You can turn off the intelligent LCD screen at any time by pressing the DISPLAY button below the screen.
2
The intelligent LCD screen will
show output power and “Hours To
Empty”. (Press the DISPLAY button to turn
off this screen if desired)
Plug your item(s) into your Battery
Generator and press the
button to activate the outlets.
(Example shown: USB ports)
NOTE: If your device's power cycles between
high and low modes, the “Hours To Empty”
time will also cycle. The actual run time will
be an average.
120V AC
USB
12V
DISPLAY
2.4 A
2.4 A
3.0 A
WATTS
HOURS
TO EMPTY
1
Power-Save Off Mode
USE THIS
MODE FOR
CPAP
AND
OTHER
LOW-DRAW
APPLIANCES
To conserve power, each output is designed to automatically turn off if there is less than 5W-AC or 100mA-USB/12V power output for more than five hours. However, you can over-ride this
power save feature by simply pressing and holding the corresponding On/Off button (AC/USB/12V) for 3 seconds.
1
Press the On/Off button located
near the output. Hold for three
(3) seconds.
3
Turning the output “Off” will
reset the port to its default
power save mode.
2
While in over-ride mode, the
output LED will flash.
120V AC
USB 12V
DISPLAY
2.4 A
2.4 A
3.0 A
120V AC
USB
DISPLAY
2.4 A
2.4 A
3.0 A
120V AC
USB
DISPLAY
2.4 A
2.4 A
3.0 A
3
SECONDS
1 2 3
PRESS / HOLD
TURN OFF
TO RESET
Getting Started (cont’d)