Operating instructions

15
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
This appliance is equipped with a push button piezo ignition device which can be used to light the pilot. If the piezo
fails to ignite the pilot, then follow the instructions for lighting pilot with match.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
+ Do not try to light any appliance.
+ Do not touch any electrical switch; do not use any phone in your building.
+ Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
+ If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control handle. Never use tools. If the handle will not push in or turn
by hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in fire or
explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information previously listed above.
2. Turn gas control knob clockwise to the “OFF” position. Do not force. (FIG. 5)
3. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow
“B” in the safety information above on this label. If you don’t smell gas, go to the next step.
4. Locate pilot - follow metal tube from gas control. The pilot is mounted on a bracket that is fastened to the side of the
right hand cradle. (FIG. 4)
5. Turn knob on gas control (FIG. 5) counterclockwise to the “PILOT” position.
6. Push in control knob all the way and hold in. While still holding the control knob, press in the igniter push button
(FIG. 5) several times. This will cause a spark at the pilot burner which will ignite the pilot flame. Continue to hold
the control knob (FIG. 5) in for about (1) minute after the pilot is lit. Release knob and it will pop back out. Pilot
should remain lit. If it goes out, repeat steps 1 through 6.
+ If the knob does not pop out when released, stop and immediately call your service technician or gas supplier.
+ If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or
gas supplier.
+ LIGHTING PILOT WITH MATCH: Turn control knob (FIG. 5) to the “PILOT”position. Place a lit match at the
pilot burner (FIG. 4), then push the knob in. Continue to hold the control knob in for about one (1) minute after the
pilot is lit. Release knob and it will pop back out. Pilot should remain lit. If it goes out, repeat the above step.
+ If the pilot will not stay lit after several tries, turn the gas control knob (FIG. 5) to “OFF” and call your service
technician or gas supplier.
7. Turn knob counterclockwise to “HI” or “LOW”.
TO TURN OFF GAS TO APPLIANCE
Turn gas control knob (FIG. 5) clockwise to the “OFF” position. Do not force. If optional power is used, it must be
turned off.
FIG. 4
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
FIG. 5
IGNITER
CONTROL KNOB
IGNITER
PILOT BURNER