Use and Care Manual

Page 11
8. Align the door to the cabinet and secure it with the bottom hinge pin and
bracket by inserting the 4 screws into the holes. Tighten the screws. Make
sure the leg is tightened in the front hole of the bracket.
9. On the right side of the unit, reinstall the previously removed leveling leg.
10. Make sure the top of the door is aligned with the cabinet and insert the top
hinge pin into the top of the door.
11. Secure the worktop with the 3 previously removed screws. Insert the 3 screw
covers over the screws.
SET UP & USE
STARTING YOUR NEW FREEZER
1. After cleaning your freezer thoroughly. Wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.
2. Insert the power supply cord into the socket.
3. Turn the thermostat dial to an initial setting of “3” for 24 hours and then set the
freezer to your desired setting.
NOTE: · As the door gets pressed in during shipping, the gasket may have to be reset. This is
done to prevent the cool refrigerated air from escaping. If there is a gap between the
door gasket and the cabinet, set the gasket by gently pulling it out of the seal gap.