Use and Care Manual

Page 16
CLEANING & CARE
DOOR GASKET
Clean door gaskets every three months according to general instructions.
Gasket must be kept clean and pliable to assure a proper seal.
• Petroleum jelly applied lightly on the hinge sides of gaskets will keep the
gasket pliable and ensure a good seal.
VACATION AND MOVING CARE
• When going on vacation, it is best that you empty all the food from your
freezer. Set the temperature dial to “OFF” and unplug the freezer. Clean the
unit as per “Cleaning Method” and leave the door open to remove any odors.
• When travelling or moving the freezer, always transport the unit vertically.
Moving the unit on its sides may damage the freezer and/or its compressor.
HOW TO DEFROST
• Defrost the freezer when the frost accumulated is about 1/8” thick.
• Set the temperature control dial to “OFF” before defrosting. Remove all
contents from the freezer compartment and leave the door open until ice and
frost dissolve thoroughly. Make sure a drip tray (not included) is in place and
unplug the unit. After defrosting, empty water from drip tray and wipe the
compartment dry with a soft cloth and then adjust the temperature control
dial to the desired position.
NOTE: · In case you want to speed up the defrosting, you may put a bowl of warm water
(about 122°F) into the freezer.
· Do not heat the evaporator directly with hot water or hair dryer while defrosting.
Doing so will damage the freezer compartment.
· Never use a sharp or metallic instrument to remove frost as it may damage
the freezer and puncture the cooling coils. It will also void the warranty. We
recommend using a plastic scraper.