Installation Guide

10
Surface Mounting (continued)
6
Making the electrical connections
□ Connect the hot and neutral (black and white) wires from
the power supply box to the same color wires from the
electrical box.
□ Connect the green wire from the power supply box to the
grounding wire from the electrical box.
□ If 0-10v dimming circuit is available, connect the purple and
gray wires from the power supply box to the same color
wires from the electrical box.
□ If dimming is not desired, wrap the ends of the purple and
gray wires with electrical tape to cover the wire.
□ Cover the wire connections using the wire connectors (EE).
□ Wrap the wire connectors (EE) with electrical tape for a
more secure connection.
Power Supply Box
EE
BB
A
7
Reattaching the fixture body to
the power supply box
□ Position the wires back inside the power supply box.
□ Align the screw holes in the fixture body (A) with the
screw holes in the power supply box, making sure all
wiring is thoroughly tucked inside the power supply box.
□ Fasten the fixture body (A) to the power supply box with
the previously removed screws, using the power tool hex
bit (FF).
A
Power Supply Box
FF
8
Restoring power
□ Restore power at the electrical panel.
□ Turn on the light switch to activate the fixture.