Installation Guide

11 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Downrod Mounting
FF
1
Removing the power supply box
Remove the four screws that attach the power supply box to the LED fixture body (A) using the power tool hex bit (FF).
Put the screws aside as they will be needed to reattach the power supply box to the fixture body (A) in a later step.
Lift the power supply box from the fixture body (A) and unplug the Quick Connect wires.
Quick
Connect
Power Supply Box
A
A
Power Supply Box
2
Preparing the power supply box for mounting
Remove the center knock-out on the power supply box.
Attach one hook from each of the two cable sets (BB) to the hanging holes on the power supply box.
Close the open hooks attached to the power supply box with pliers. Do not close the open S hooks at the bottoms of the
cable sets.
Center Knock-out Hole
BB
Power Supply Box
Power Supply Box
Hanging Holes
Hanging
Holes