Installation Guide

5 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
2
Preparing the power supply box for wiring
□ Remove the knock-out near the end of the power supply box.
□ Fit a 1/2 in. snap-in bushing into the knock-out hole.
□ Feed the wiring out through the bushing and knock-out hole.
□ Reconnect the two ends of the Quick Connect wires.
□ Align the screw holes in the fixture body (A) with the screw holes in the
power supply box.
□ Fasten the fixture body (A) to the power supply box with the
previously removed screws, using the power tool hex bit (FF).
Suspension Mounting (continued)
3
Mounting to drywall
□ Drill two holes large enough to clear the closed flaps of the
butterfly nut on the toggle bolt (not included).
□ Fasten the toggle bolt into the butterfly nut before
inserting the flaps into the ceiling.
□ Tighten the toggle bolt.
4
Mounting to wood
□ Drill two 1/16 in. diameter holes in the ceiling to
accommodate hook screws (not included).
□ Fasten the combo wood-machine end into the metal hook.
□ Tighten the hook screw (not included) into the wood.
FF
Knock-out Hole
Power Supply Box
Power Supply Box
A
Quick
Connect
A
Power Supply Box