Instructions / Assembly

2
Safety Information
WARNING: Carefully read and understand the information
given in this manual before beginning the assembly and
installation. Failure to do so could lead to electric shock, fire,
or other injuries which could be hazardous or even fatal.
WARNING: Ensure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn off the
circuit breaker.
WARNING: Risk of fire or electric shock. Installation of this
LED Retrofit Kit assembly requires a person familiar with the
construction and operation of the light fixture’s/luminaire’s
electrical system and the hazard involved. If not qualified,
do not attempt installation. Contact a qualified electrician.
WARNING: Install this kit only in luminaires (light fixtures)
that have the construction features and dimensions shown
in the photographs and/or drawings included in these
installation instructions, and where the input rating of the
retrofit kit does not exceed the input rating of the luminaire.
WARNING: Do not make or alter any open holes in an
enclosure of wiring or electrical components during kit
installation.
WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other sharp objects.
NOTICE: The retrofit kit is accepted as a component of a luminaire
where the suitability of the combination shall be determined by
authorities having jurisdiction. Product must be installed by a qualified
electrician in accordance with the applicable and appropriate electrical
codes. The installation guide does not supersede local or national
regulations for electrical installations.
NOTICE: Suitable for type IC for type non-IC installation.
NOTICE: Use only in open luminaires.
NOTICE: Luminaire wiring and electrical parts may be damaged when
drilling for installation of LED retrofit kit. Check for enclosed wiring and
components.
NOTICE: This device is not intended for use with emergency exits.
NOTICE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
□ Reorient or relocate the receiving antenna
□ Increase the separation between the equipment and the receiver.
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTICE: Minimum lamp compartment dimensions for Model #
53804101: 6 inch diameter and 8 inch depth when used in a 6-inch
recessed luminaire.
NOTICE: Minimum lamp compartment dimensions for Model #
53805101: 4 inch diameter and 8 inch depth when used in a 4-inch
recessed luminaire.
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Warranty ...................................................3
Pre-Installation .........................................3
Planning Installation ..............................3
Tools Required .......................................3
Package Contents ..................................3
Installation ................................................4
Adjusting the Color Temperature
of the Light ............................................5
Selecting Downlight or Nightlight Mode ..5
Care & Cleaning ........................................6
Troubleshooting ........................................6
Light Distribution ......................................7