Installation Guide

7 HOMEDEPOT.COM

Please contact 1-877-527-0313 for further assistance.

Installation (continued)

Attaching the housing to the ceiling

□ Drill a 1/8 in. pilot hole into the screw locations marked on the ceiling. You can also use an awl or nail to dimple the screw holes.

□ Install a drywall anchor (FF) and a mounting screw (GG) in each drilled mounting hole, but do not tighten fully.

□ Align the 2 mounting keyholes on the housing (A) with the 2 mounting screws in the ceiling. Once both screw heads are through the

large ends of the keyholes, slide the housing until the heads of the screws slide into the narrow ends of the keyholes.

□ Finish tightening the mounting screws (GG) until the ﬁxture housing (A) is tightly secured to the mounting surface.

Attaching the diffuser to the

housing

□ Insert one end of the diffuser (B) into the

end cap of the housing (A) to the bottom of

the limit part.

□ Push the other end of the diffuser (B) to the

top of the limit part on the opposite end cap.

□ Restore power to the electrical box. Turn on

the light switch to activate the ﬁxture.

NOTE: The drywall anchors (FF) are only to be used for mounting the ﬁxture onto plaster or drywall surfaces.

Limit part