Installation Guide

6
Installation (continued)
6
Attaching the diffuser to the housing
□ Reconnect the terminal ground wire (D) from the wire way cover (C) to the fixture housing (A).
□ Reattach the wire way cover (C) to the wrap light housing (A) by squeezing the wire way cover (C) and
inserting the tabs into the openings in the housing (A).
NOTE: If electrical connections are inside the wrap light housing (A), ensure the wire connections are
covered by the wire way cover (C).
□ Insert one end of the diffuser (B) into the end cap of the housing (A) to the bottom of the limit part.
□ Push the other end of the diffuser (B) to the top of the limit part on the opposite end cap.
□ Restore power to the electrical box.
□ Turn on the light switch to activate the fixture.
Limit
part
D
C
B
B
A
A
A