Installation Guide

HOMEDEPOT.COM/HUBSPACE or
HOMEDEPOT.CA/HUBSPACE
Please contact 1-877-592-5233 for further assistance.
FCC Notice
NOTICE: This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference can be determined by turning the equipment off and on, so the user is encouraged
to try to correct the interface by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the device and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
IC Notice
Troubleshooting
9
Problem
Solution
The
light will not turn on.

Make sure the power supply is on.

Test or replace the switch.

Check the wiring.

Replace the driver.
The
fuse blows or circuit breaker trips
when light is turned on.

Check the wire connections.
“Wi
-Fi
has been set up, but there doesn’t
appear to be an internet connection.
Check your local network.” message
shows on the screen.

The message may be false. Close it and
see fi the fixture has connected and is
operating properly.
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
FCC responsible party: Cordelia Lighting
Address: 20101 S Santa Fe Avenue
East Rancho Dominguez, CA 90221
Phone: [phone]
!
Conforms to standard CAN-ICES 005 (B) / NMB-005 (B)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.